Nominal
width:
|
1.800mm - 1.600mm |
| Speed: |
900 rpm - up to 1.050
rpm |
| REED WIDHT: |
1.600 MM - 1.200 MM |
| WEFT INSERTION: |
FROM 1.260 UP TO 1.440
(METERS PER MINUTE) DEPENDING ON PATTERN |
| REPEAT: |
FIELDS 8X20 CM EACH
AND 6X20 CM EACH DEPENDING ON THE CONFIGURATION |
| NUMBER OF COLOURS: |
8 COLOURS |
| WARP: |
POLYESTER |
| WEFT: |
POLYESTER FROM 20DEN
TO 200DEN, LUREX AND OTHERS |
| DIALOG PANEL II |
HIGH LEVEL OF MACHINE
INTELLIGENCE SINCE AL ELEMENTS INVOLVED IN
FILLING INSERTION ARE ELECTRONICALLY CONTROLLED |
| AUTOMATIC FILLING REPAIR
AFR |
NO MANPOWER REQUIRED
TO RESTART THE LOOM AFTER WEFT STOP. EFFICIENCY
HIGHLY INCREASED, AND FEWER OPERATORS PER
LOOMS ARE REQUIRED |
| ELECTRONIC FILLING TENSION
EFT |
TO REDUCEYARN STRESS
DURING FILLING INSERTION AND THEREFORE TO
REDUCE BREAKS DOWN |
| ELECTRONIC WARP LEFT-OFF
MOTION EWL |
TO FACILITATE HIGH QUALITY
PRODUCTIONS THE WARP LET OFF STSTEMIS CONTROLLING
FILLING DENSITY AND OPERATING SPEED.THE SYSTEM
ENSURE COSTANT QUALITY AND PREVENT START MARKS. |
| THERMAL CUTTING SYSTEM: |
PATENTED MEI "SUPER
SOFT SELVEDGES" WITH RIVETS |
| WEFT FEEDERS: |
ROY AND LGL |
| FABRIC TENSION CONTROL: |
BY SUPPLEMENTARY CONTINUOS
CURRENT MOTORS TO ENSURE COSTANT RIBBON TENSION |
| POWER CONSUMPTION: |
10 KWH (AT RUNNING CONDITION)
- 18 KWH (AT START-UP) |
| AIR CONSUMPTION: |
FROM 75 TO 100 CUBIC
METERS PER HOUR AT 3/3,5 BAR PRESSURE |
| ARRIVAL LINE PRESSURE |
7 BAR |
| MAINTENANCE: |
EXTREMELY REDUCED. NEGLIGIBLE
COMPERED TO RAPIER LOOMS |
| GANTRY: |
ON LOOM |
| JACQUARD: |
BONAS ZJS AND STAUBLI
LXE AND SX |
| HARNESS: |
WITH SPRINGS PULL DOWN |
| NEW: |
SYNCRO MOTOR VERSION
New drive concept FT SyncroDrive
Highly dynamic back rest roller type |
